美隆電子有限公司

Mayloon Electronic Co., Ltd.,

  • 增加字體大小
  • 預設字體大小
  • 減少字體大小

Fusible Resistor - RF series

RESISTOR

SINLOON® 溶斷保險絲電阻 FR SERIES
Power Rated: 1/4W ~ 3WS Fusible Resistor
Fusible Resistor - RF Series
EATURES igure
The Fusible resistor is applied to safety circuit in wide range of electronic sets. 溶斷電阻 按圖放大
Fusing Resistor - FR
Complete flame proof construction resistance range 0.33R ~ 1K ohm
Resistance tolerance  ±2%, ±5%.
There are 5 color band is in write color means wire wound fusible resistor - - -
The fusing time 60/sec Max.
NTRODUCTION - - -
FR Type (Standard)
Rated power : 1/4W ~ 2W; 1/2WS ~ 3WS.
Superior quality fusible resistors which are flameproof during operation - - -
These resistors fuse  in less than 30 seconds at 16 times rated power
XTERNAL DIMENSIONS
Type Power DIMENSION (mm) Dimension (本體尺寸)
L ΦD H Φd
FR025 1/4W 6.3±0.5 2.3±0.3 28±2 0.55±0.03
FR50S 1/2WS 6.3±0.5 2.3±0.3 28±2 0.55±0.03
FR50 1/2W 9.0±0.5 3.2±0.5 28±2 0.65±0.03
FR100S 1WS 9.0±0.5 3.2±0.5 28±2 0.65±0.03 -
FR100 1W 11.5±1.0 4.5±0.5 35±2 0.78±0.03
FR200S 2WS 11.5±1.0 4.5±0.5 35±2 0.78±0.03
FR200 2W 15.5±1.0 5.0±0.5 35±2 0.78±0.03
FR300S 3WS 15.5±1.0 5.0±0.5 35±2 0.78±0.03
ATED POWER
Type Power Limiting Element Resistance Resistance Operating
Voltage Range Tolerance temperature Range
FR025 1/4W 200V 1R~1KΩ G=±2% J=±5% -40~ +155
FR50S 1/2WS 250V 1R~1KΩ
FR50 1/2W 250V 1R~1KΩ
FR100S 1WS 300V 1R~1KΩ
FR100 1W 300V 1R~1KΩ
FR200S 2WS 350V 1R~1KΩ
FR200 2W 350V 1R~1KΩ
FR300S 3WS 400V 1R~1KΩ
Remark: The products value range for standard resistance, below or over this resistance on request please contact us. 返回
: 如有低於或高於規格參數阻值的要求請聯絡我們
 
歡迎您瀏覽本網站 WELCOME TO MAYLOON
Mayloon Electronic Company Limited Mayloon Lighting Company Limited

Mayloon on-line chat now

即時業務接洽
WhatsApp:91808452
QQ:1247069489
E-mail: peter@mayloon.com
TEL:852-2408 9788 M: 9180 8452

消息

美隆照明有限公司
承接換燈照明工程:
更新換舊
各類型照明燈具
瑩光燈管換LED燈管
包括:燈管支架/有罩燈盤/格柵燈盤等
歡迎來電查詢
MP.:91808452

Newsflash

如何可以提供更高功率的電阻

 MELF Carbon Film Resistor - MCF  

 Home-CR  如何可以提供更高功率的電阻:

電阻形式種類繁多,但功率型電阻最常用的一般是繞線電阻和水泥電阻,在相同類別封裝的尺寸要加入更大的功率,無論它用於大型工業設備還是小型的電子商品,如要獲得較大的額定功率,電阻必須不能產生過量的熱,過量的熱會導至功率下降及阻值的變化,所以在電阻領域,電阻外型封裝越大,電阻能夠處理的功率相對就越高.當今電子商品要求越來越小,這意味著要求較小的被動元件,如何迎合這一形勢的市場要求,

必須要有更好的散熱性能的基體和更小容差的綜合材料來達到更高的相應功率,美隆電子有限公司 已經可以做到這點,提供更高功率的新型電阻.無論是貼片封裝電阻還是大功率的 TO220 封裝電阻,在同類相同尺寸相比之更強了.現在我們已經正在增強電阻功率的要求,以期在相同型號類別或更小的尺寸封裝,做到高效的散熱性能和更高的功率來满足市場的要求.

我們現在已經可以做到工作於275的電阻,這些電阻能夠耐受汔車和工業應用中的惡劣環境條件,無論你要求的散熱電阻還是表面黏裝的貼片電阻,我們都做到了,歡迎您來電查詢.